BenQ MW767 Bedienungsanleitung PDF herunterladen (Seite 24)

Connection24

2. Connect the other end of the cable to the HDMI jack on the projector.

• Many notebooks do not turn on their external video ports when connected to a projector.

Usually a key combo like FN + F3 or CRT/LCD key turns the external display on/off. Locate a

function key labeled CRT/LCD or a function key with a monitor symbol on the notebook.

Press FN and the labeled function key simultaneously. Refer to your notebook's

documentation to find your notebook's key combination.

• Transmission speed and image quality will vary according to the bandwidth of local area

network and the status of network usage.

Connecting a monitor

If you want to view your presentation close-up on a monitor as well as on the screen, you

can connect the MONITOR OUT signal output jack on the projector to an external

monitor following the instructions below:

To connect the projector to a monitor:

1. Connect the projector to a computer as described in "Connecting a computer" on

page 23.

2. Take a suitable VGA cable (only one supplied) and connect one end of the cable to

the D-Sub input jack of the video monitor.

Or if your monitor is equipped with a DVI input jack, take a VGA to DVI-A cable and

connect the DVI end of the cable to the DVI input jack of the video monitor.

3. Connect the other end of the cable to the MONITOR OUT jack on the projector.

• The output signal for MONITOR OUT jack only works when the input signal comes from

COMPUTER 1 or COMPUTER 2 jack. When the projector is powered on, the output signal

from MONITOR OUT jack varies depending on the input signal from COMPUTER 1 or

COMPUTER 2 jack.

• If you wish to use this connection method when the projector is in standby mode, make sure

the

Monitor Out function is turned on in the SYSTEM SETUP: Advanced > Standby

Settings menu. See

"Standby Settings" on page 73 for details.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 106 107

Keine Kommentare

BenQ MW767 Bedienungsanleitung Seite 24