Benq MP611 Bedienungsanleitung PDF herunterladen (Seite 30)

Operation26

Switching input signal

The projector can be connected to multiple devices at the same time. However, it can only

display one at a time.

When SOURCE on the projecotr control panel

or the remote control is pressed, information of

current signal and resolution will display at the

lower right corner. Press SOURCE again to

display a source selection bar. You can manually

press SOURCE repeatedly until your desired

signal is selected or let the projector

automatically search for the availabel signal.

Once detected, the selected source information

will display at the lower right corner of the

screen for 3 seconds. If there is multiple

equipment connected to the projector, you can

press the button again to search for another

signal.

Be sure the Source Scan function in the Advanced menu is activated if you want the

projector to automatically search the signals. See "Source Scan (on)" on page 41 for details

The brightness level of the projected image will change accordingly when you switch between

different input signals. Data (graphic) "PC" presentations using mostly static images are

generally brighter than "Video" using mostly moving images (movies).

The input type affects the options available for the Application Mode. See "Selecting a picture

mode" on page 29 for details.

Adjusting the projected image

Adjusting the projection angle

The projector is equipped with 1 quick-release adjuster foot and 1 rear adjuster foot. These

adjusters change the image height and projection angle. To adjust the projector:

1. Lift the projector up and press the

adjuster button to release the

adjuster. The adjuster will drop

into position and be locked.

Do not look into the lens while the lamp is

on. The strong light from the lamp may

cause damage to your eyes.

2. Screw the rear adjuster foot to fine

tune the horizontal angle.

To retract the foot, hold up the projector

while pressing the quick-release button, then slowly lower the projector. Screw the rear

adjuster foot in a reverse direction.

If the screen and the projector are not perpendicular to each other, the projected image

becomes vertically trapezoidal. To correct this situation, adjust the value of Keystone in the

Picture menu, on the projector control panel, or on the remote control. See "Correcting

keystone" on page 27 for details.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Benq MP611 Bedienungsanleitung Seite 30

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Projektoren Benq MP611